Solid wood flooring
Solid wood flooring construction
Solid wood installation instruction
|
Construction Procedures and Points for Attention |
|
|
1. The cement ground on which wooden floor tiles are to be installed should be dry and flat.
2.Scatter some inspect prevention powder on the ground before spread
tar papers which should be overlapped for 20cm ,and be spread on the foot of
wall for over 10cm. |
 |
|
3. Two methods of installation:
B. In order to install the floor tiles more flatly and firmly, plywood 6 to 9cm thick should be spread on the rising wood .A gap of 2to 4mm should be left between the wall and the plywood. |
 |
|
4. Hammer the grooves and tongues of floor tiles to joint them firmly. There should be a margin of at least 9mm between floor tiles and the wall. After the installation is finished, cover the margin with skirt board. Nails must be punched into the grooves or tongues of floor tiles diagonally with hardwood flooring nail (blind nail). Never use any kind of glue between floor tiles and the plywood.
|
|
 |
|
Maintenance Instructions
 |
1. Keep the wooden floor dry and clean. Keep it away from large quantity of water. It should be cleaned with cotton mop that is wrung out .Do not use buck or suds in order to avoid damage to its paint layer. Stains can be rubbed out with steel wool .Rubbing with gasoline is forbidden because it may cause fire. |
|
2. The floor should be waxed
at regular intervals. The procedures are as follows; clean the floor
with half-dried rag, then wax it evenly, and make the wax permeate
into the surface of the floor. After the wax dries a little, rub it
with soft rag until it looks smooth and shining. |
 |
